By the time you see a stain or hear dripping, a burst pipe has often already been running for a while inside the wall.
Insulation and drywall removal is targeted, and we coordinate directly with a licensed plumber for the actual pipe repair.
We'll walk you through shutoff steps over the phone if you call before we arrive.
Our Edgemoor, SC crews trace pressure loss to identify the failure point before opening drywall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
We coordinate directly with a licensed plumber for the actual pipe repair once our mitigation work is done.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Edgemoor, SC crews run it.
If the source is still running, shutoff is priority one.
Diagnostics narrow down the exact wall section affected.
Wall cavity extraction addresses moisture a surface-level approach would miss.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
Specialized drying equipment reaches into open wall cavities to dry framing and remaining materials.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
Tell our Edgemoor, SC dispatcher if the water source is still running so we can advise on shutoff immediately.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
Sudden water flow or a fast-spreading stain typically points to a burst rather than a slow leak.
Only the compromised section comes out, not the full wall.
We handle the water damage mitigation and coordinate directly with a licensed plumber for the pipe repair itself.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Drying time depends on cavity size and how long water was actively leaking before shutoff.
Edgemoor sits within our core burst pipe response zone.
Call now and we'll help you locate the shutoff valve over the phone if needed.
Call +1-844-833-1325